Mia Noi – Naming

About a month after the paint job was complete, I finally got around to putting on Mia Noi’s lettering and making her new name complete. She now had a personality and home port! I purchased the name, numbers and lettering from US Boat. The sticky letters were easy to install.

Advertisements

Mast Up!

Originally I was going to hire a rigger to rig my mast – but in the end I decided to save a few dollars and do it myself. I’m really happy I did. Again, it was a great educational experience to learn, make a few mistakes and feel confident knowing every part of the boat. Ruben at Seamark Marine used a hoist to raise the mast which made the job a cinch.

Transom Thru-Hole

A previous owner of My Catalina had installed a bilge pump which is great, but for some reason the bilge pump was connected to a thru-hole that emptied into the cockpit. It meant the water was trapped onboard – a potential disaster waiting to happen! So, the first major improvement I undertook was to reinstall the thru-hole, this time via a hose running out the Port-side transom.

Test Drive

More than two months after I purchased ‘Mia Noi’, I finally got to give her a ‘road test’ in Marina Del Rey. It was a great feeling to drive off from Seamark Marina with ‘Mia Noi’ in tow. I was a little trepid as a reversed the trailer down the ramp – wondering in the  back of my mind if ‘Mia Noi’ would sink or float as her transom began to touch the salt water of the Pacific Ocean! The outboard started immediately using the electric start. Afloat .. I took ‘Mia Noi’ for her first ‘motor’ around Marina Del Rey, happy my dreams were coming true!

A Sailor’s Best Friend

When I purchased ‘Mia Noi’ she came with an 8HP two-stroke outboard. She started – was a little smokey and would do the job. But, for safety reasons and personal reassurance I purchased an new four-stroke Nissan 8HP outboard. It’s a good fit for my Catalina and I wanted to make sure I had a best friend out on the water if the weather turned un-friendly! The transom was reinforced with a plastic plate to assist in accommodating the 90 pound outboard, I also purchased a new bracket for the engine.

Seamark Marine

The refurbishment of my Catalina 22 was completed by Seamark Marine at Marina Del Rey. Ruben Flores, Seamark Marine’s Owner/Operator is honest, generous with his time and advice – plus he did a great job painting and repairing my Catalina 22 ‘Mia Noi’. Ruben allowed me to do the small stuff, such a re-wiring the mast and removing the hardware from ‘Mia Noi’. I recommend Seamark Marine if you need work done on your sailboat or motorboat. The majority of boat repair yards in Marina Del Rey prefer to work on new boats. Ruben and his team are different, old or new – no job is too difficult and you’ll be happy with the results.

Spray Job – The Body Paint

Finally Los Angeles’ unseasonably wet weather turned back to its traditional 85 degrees and sunshine – and the final deck coat was sprayed on. Ruben Flores and his Seamark Marine team prepped the boat and went to work painting ‘Mia Noi’.

Parking Spot

A major reason I purchased ‘Mia Noi’ is because of her trailerbility. In Marina Del Rey, Los Angeles County Department Of Beaches and Harbors has a mast up storage facility. I was able to get a spot in the mast up storage area, 50 meters from the boat ramp.

Trailer Upgrade

The original air-brake coupler on the trailer was very stiff and difficult to mount and remove from my Jeep’s hitch. So I decided to grind, cut off the air-brake coupler and replace it with a simple trigger latch coupler.

Mast Step Plate

As I was upgrading to ‘all lines aft’, I needed to install a mast step halyard plate. The mast step currently on the boat needed a bit of elbow grease to remove, it had been updated and installed by the previous owner about 12 months before I purchased the boat.